Les Paul Wiring Harness Custom 525k CTS LONG Shaft Mallory 150 Mustard .022 uF Caps

$49.95

Jackson Electronic Luthier ®

525k ohm Ω LONG Shaft

Note: Does not come with 3-way switch or jack

Les Paul ® Type Wiring Harness 50s Style Wiring Harness

Mallory 150 .022uF 630VDC Caps 5% Tolerance

CTS TAOT 525k LONG Shaft Audio Pots.

YellowVarnish Spaghetti Tubing

Description

This is the famous Mallory® Mustard Cap used on just so many high end guitars.

This .022 uF cap is most commonly used with humbuckers where less high end bleed is required. These are great sounding tone caps for your guitar. These are great for humbucker or single coil equipped guitars

The quickest and easiest mod you can make to your guitar. Just replace the original tone caps with these. Even if you don't use your tone control, you'll hear a difference.  

These are an excellent replacement upgrade for guitars with humbuckers or single coils

I like these polyester caps and have upgraded many guitars with them

Upgrade the Sound and tone of your Guitar with the high quality Mallory 150 series capacitors. Experience smooth tone and high reliability. Mallory 150 series are tubular metalized polyester capacitors rated for 630V with 5% tolerance. Their great tone makes them a premium upgrade for tone improvement. Generally, they are a bit warmer and smoother than Sprague Orange Drops. They have a tendency to "round off" harsh overdrive sounds.

All Harnesses come signed with individual Serial Numbers.

Mallory "Mustard" Tone Capacitor .022 uf 630V

This is the famous Mallory® Mustard Cap used on just so many high end guitars. This .022 uF value cap is most commonly used with humbuckers where less high end bleed is required. These are great sounding tone caps for your guitar.

 

.022uF is common value in Gibson and Gibson-style guitars using Humbucker pickups. A very nice upgrade.

All Harnesses come signed with Individual Serial Number.

Specifications

Wired with 20 AWG Bus Wire

Comes with Instructions

Build is a 5% Tolerance Build which produces a Superior Tone than a 10% build tolerance.

If you’re in doubt ask the Harness Maker what their Tolerances are and can you see their test reports.

Many Builds are 10% Tolerance and some are even 20% Tolerance.

CTS 525k TAOT Potentiometers and Mallory 150 Capacitors, as well as all materials used, Comes With Complete Test Reports and Specifications and Instructions.

The Capacitors are 0.022uF at the neck and .022uf at the bridge.

Testing
The Harness is Tested Using Advanced Audio-Metric Software feed to an AC30 HW Vox Amp.

Many Harness Makers only Test for Continuity.

Please Note: